DLP printed 3D gyroid structure: Mechanical response at meso and macro scale

Rapid prototyping (RP) technology enables the fabrication of complex geometries, making lattice structures increasingly popular. Lattice structures, known as cellular materials, have garnered significant attention over the past two decades due to their ability to optimise mass distribution in components. These structures excel in mechanical properties, catering to energy absorption (bending-dominated structures) and structural performance (stretch-dominated structures). In this paper, we investigate the behaviour of stretch-dominated lattice structures using periodic surface models, specifically focusing on sheet-based Gyroid cells, to allow for a more efficient macroscale modelling. We study cells and scaffolds of different sizes, considering various triply periodic minimal surface thicknesses and relative densities ranging from approximately 0.2 to 0.65. We explore load applications in directions different from the unit cell's principal axes and analyse the strain rate effect on both bulk and cellular material. The lattice structures are manufactured using epoxy resin and digital light processing (DLP) technology. In the range of relative density investigated, both in quasi-static and dynamic conditions, a linear trend is observed for Young's modulus and compression yield strength. To extend the quasi-static results to the dynamic regime, we employ a more generalized normalization technique. This approach divides Young's modulus and compression yield strength by the behaviour of the base material at a specific strain rate, facilitating the correlation of mechanical properties across the two loading regimes. Based on experimental findings, we implemented and calibrated a bi-linear material model for describing, in macroscale, triply periodic minimal surface (TPMS) Gyroid structures. The model coefficients are parameterized with respect to relative density. In addition, the presented material law was compared with that proposed by Gibson-Ashby. Furthermore, we evaluated the anisotropy of both the base material and the unit cell. The first one is done by testing the 3D printed samples in directions different from the printing one, the latter by using the Zener factor. The anisotropy evaluation confirmed the isotropic behaviour of the unit cell within the range of relative density and test conditions investigated. Finally, we perform linear elastic 3D macroscopic and mesoscopic model simulations for combined shear-compression tests using the implemented bi-linear material model and the anisotropic stiffness matrix (obtained through the homogeneous formulation) for the macroscale, and the base material for the mesoscopic one. The results demonstrate the suitability of the proposed equivalent material model for studying the TPMS Gyroid structure in the elastic regime, both in quasi-static and dynamic states. This allows for an efficient FE modelling process of complex lattice structures.