High-Temperature Equal-Channel Angular Pressing of a T6-Al-Cu-Li-Mg-Ag-Zr-Sc Alloy

Equal-channel angular pressing (ECAP) is known to induce significant grain refinement and formation of tangled dislocations within the grains. These are induced to evolve to form low-angle boundaries (i.e., cell boundaries) and eventually high-angle boundaries (i.e., grain boundaries). On the other hand, the precipitation sequence of age hardening aluminum alloys can be significantly affected by pre-straining and severe plastic deformation. Thus, ECAP is expected to influence the T6 response of aluminum alloys. In this study, a complex Al-Cu-Mg-Li-Ag-Zr-Sc alloy was subjected to ECAP following different straining paths. The alloy was ECAP at 460 K via route A, C, and by forward-backward route A (FB-route A) up to four passes. That is, ECAP was carried out imposing billet rotation between passes (route A), billet rotation by +90 degrees between passes (route C), and billet rotation by +90 degrees and inversion upside down between passes (FB-route A). The alloy was also aged at 460 K for different durations after ECAP. TEM microstructure inspections showed a marked influence of the different shearing deformations induced by ECAP on the alloy aging response. The precipitation kinetics of the different hardening secondary phases were affected by shearing deformation and tangled dislocations. In particular, the T-1-Al2CuLi phase was the one that mostly showed a precipitation sequence speed up induced by the tangled dislocations formed during ECAP. The T1 phase was found to grow with aging time according to the Lifshitz-Slyozov-Wagner low-power regime.